Filter
Top Products
Using the LitePro 760
18 LitePro 760 User’s Guide
Adjusting the Height
Your LitePro is equipped with a self-locking, quick-release elevator
foot. If the projected image seems wider at the bottom than at the top,
extend the elevator foot until the distortion is corrected.
To raise the LitePro:
1.
Raise the front of the projector off the table by lifting up on the
handle.
2.
Press the quick-release button (just inside the handle). The eleva-
tor foot releases.
3.
Gently lift or lower the projector to the desired height. When you
release the handle, the elevator foot locks into position.
4.
To more closely adjust the projector’s height, rotate the elevator
foot clockwise to raise the projector. Rotate it counterclockwise to
lower the projector.
To lower the elevator foot:
• Holding the LitePro handle, press the elevator’s quick release
button. Push the elevator back up into the projector.
Always hold the LitePro’s handle when you press the
elevator’s quick release button.
Osprey.bk Page 18 Monday, December 11, 2000 1:38 PM