Filter
Top Products
Connecting the LitePro 760
8 LitePro 760 User’s Guide
Connecting a Sun, SGI, Intergraph or NeXT Workstation
Follow this procedure if your computer is a Sun SPARCstation, SGI
Indigo or Indy, Intergraph 2400 or 6400, or color NeXTstation.
1.
Locate your monitor cable; it connects the monitor to the com-
puter. Unplug it from the computer. Remember where you
unplugged the cable from the computer, you will plug the
LitePro cable into this same connector in the next step.
2.
Attach one of the 13W3 adapters to the “Computer” end of the
LitePro cable.
• If your computer is an SGI, plug the “SGI” end of the adapter
into the “Computer” end of the LitePro cable. For other
computers, use the “Other” connector.
3.
Plug the adapter (with the cable attached) into the monitor con-
nector on the computer.
4.
Attach the other 13W3 adapter to the “Monitor” end of the
LitePro cable.
• If your computer is an SGI, plug the “SGI” end of the adapter
into the “Monitor” end of the LitePro cable. For other
computers, use the “Other” connector.
5.
Plug the adapter (with the cable attached) into the computer’s
monitor cable.
6.
Tighten the thumb screws on all the connectors to ensure proper
grounding.
7.
Turn on the monitor.
8.
Turn on the LitePro 760 by pressing the “1” side of the power
switch. (Refer to “Powering Up the LitePro” on page 15.)
9.
Turn on the computer.
Osprey.bk Page 8 Monday, December 11, 2000 1:38 PM