Filter
Top Products
Maintenance
LitePro 760 User’s Guide 31
Replacing the Fuse
A power line surge or spike can blow the power supply fuse and
cause the LitePro to stop working. If this happens, you’ll need to
replace the fuse.
Use only the specified power supply fuse. Using a different
fuse may cause serious damage to the LitePro.
The correct fuse for your LitePro depends on the power line voltage
in the country where you are operating the LitePro.
• If your line voltage is 220V to 240V (as in most European
countries), use a 6.3 amp, 250V, 5x20 mm fuse.
• If your line voltage is 100V to 120V (as in Japan, the United States
and most North American countries), use a 10 amp, 250V, 3AB
fuse.
Follow these steps to replace the fuse.
1.
Make sure that the condition that caused the fuse to blow no
longer exists.
2.
Turn off the LitePro by pressing the “O” side of the power switch
on the side of the LitePro.
3.
Unplug the power cord from the LitePro.
4.
Locate the fuse holder on the side of the LitePro between the
power switch and the power cord connector.
Osprey.bk Page 31 Monday, December 11, 2000 1:38 PM