Filter
Top Products
Connecting the LitePro 760
10 LitePro 760 User’s Guide
Connecting an HP, DEC or IBM Workstation or
Tektronix X Terminal
Follow this procedure if your computer is an HP workstation or X
terminal, an IBM RS6000/220, a DEC VAXstation or DECstation 3100
or a Tektronix X terminal.
1.
Locate your monitor cable; it connects the monitor to the com-
puter. Unplug it from the computer. Remember where you
unplugged the cable from the computer, you will plug the
LitePro cable into this same connector in the next step.
2.
Attach one of the BNC adapters to the “Computer” end of the
LitePro cable. Plug the adapter (with the cable attached) into the
monitor connector on the computer.
3.
Attach the other BNC adapter to the “Monitor” end of the LitePro
cable. Plug the adapter (with the cable attached) into the com-
puter’s monitor cable.
4.
Tighten the thumb screws on all the connectors to ensure proper
grounding.
5.
Turn on the monitor.
6.
Turn on the LitePro 760 by pressing the “1” side of the power
switch. (Refer to “Powering Up the LitePro” on page 15.)
7.
Turn on the computer.
Osprey.bk Page 10 Monday, December 11, 2000 1:38 PM