Filter
Top Products
14
Shutting down the projector
Screen Save Time
You can make the black screen appear after a preset number of minutes by turning
on the Screen Save Time feature in the Setup menu. See page 29.
Auto Off Time
The projector has an Auto Off Time feature that automatically turns the projector
off if no active sources are detected and no user interaction with the projector is
performed for 30 minutes. By default, this feature is off. You can change the length
of time, see page 29.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp
turns off and the LED blinks amber for 10 seconds while the fans continue to run to
cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop.
Unplug the power cable to completely power off the projector.
Troubleshooting your setup
The Status Indicator Panel on top of the projector indicates the state of the projector
and is a helpful when troubleshooting.
Table 3: Status indicator light behavior and meaning
Icon Meaning
Power, solid amber
Power, blinking green
Power, solid green
Power, blinking amber
The projector is plugged in.
The power button has been pressed and the
software is initializing.
The projector
is on and initialized.
The power button has been pressed to turn
the projector
off and the fans are running
to cool the projector.
Temperature
The projector is too hot. Make sure the
vents aren’t blocked (see page 20). Turn
the projector off and wait one minute, then
turn
the projector on again. Contact
Technical Support if the problem persists.
Visit www.infocus.com/support to contact
service.
Lamp
Turn the projector off and wait one minute,
then turn the projector on again. If the
lamp light turns on again, replace the lamp
and reset the lamp timer
(page 43).
Wrench/Service
Turn the projector off and wait one minute,
then turn the projector on again. If the
service lamp turns on again, service is
required. Visit www.infocus.com/support
to contact service.