Filter
Top Products
22
Using the remote control
The remote uses two (2) AA batteries. You can install the batteries by removing the
cover from the remote’s back, aligning the + and - ends of the batteries, sliding them
into place, and then replacing the cover.
Caution:
• When disposing of the batteries, be sure to do so in an en
vironmentally proper
manner
.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Ensure the batteries’ polarity (+/-) is aligned correctly.
• Do not mix new and old batteries together
, or dif
ferent types of batteries
together.
• Replace the batteries as soon as they run out.
• Remove batteries from the remote control when storing
or not in use for a
prolonged period.
To operate, point the remote at the projector (
not at the computer). The range of
optimum operation is about 30’ (9m).
Press the remote’s Power button to turn the projector on and off (see page 14 for
shutdown information).
Press the remote’s Menu button to open the projector’s menu system. Use the arrow
buttons to navigate, and the Select button to select features and adjust values in the
menus. See page 26 for more information on the menus.
The remote also has:
• He
lp
button to access the projector’s help feature (see page 32).
• Volume
buttons to adjust the sound.
• Custom button that can be assigned to a special function, like Blank Screen or
Freeze (see page 29).
• Source button to switch between sources.
• Blank button to blank the screen.
• Presets button to select
stored settings (see page 27).
• Mute button to silence the audio.
• Auto Image button to resynchronize the projector to the source.
• Resize button to switch
among aspect ratios (see page 27).
Troubleshooting the remote
• Make sure the batteries are installed in the proper orientation and are not dead.
• Make sure you’re pointing the remote at the projector or the
screen, not the
computer, and are within the remote range of 30’ (9m). For best results, point
the remote at the projector.
Navigation
buttons