Filter
Top Products
©2001 Inova Computers GmbHPage B-8 CPU Appendix-B
ICP-HD
Appendix B
B1.8 COM1 & COM 2 Interfaces
The two COM ports feature a complete set of handshaking and modem control signals, maskable
interrupt generation and high-speed data transfer rates. A front-panel with COM1, COM2, mouse
and keyboard interfaces is either integrated into an 8HP standard CPU front-panel or available as
a separate 4HP unit. The IDE carrier board located behind these interfaces connects to the CPU-
mounted J11 and J13 connectors.
Figure B1.8 COM1 & COM2 Interface Pinout
1
6
5
9
Table B1.8 COM1 & COM2 Connector Signals
Note:
The standard CPU configuration has both
COM ports set for RS232 communication.
However, this device can be configured to
observe a two-wire, non galvanically
separated, RS485 protocol. The data
direction is governed by controlling the
UART’s RTS signal. Writing a hex value of
0B to this register allows data to be
transmitted. Writing 1B to this register
configures the device to receive data.
RS232 RS485
1 DCD
2 RxD RxD, TxD +
3 TxD RxD, TxD -
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9RI
Pin No.
Signal