Filter
Top Products
AP440FX Motherboard Technical Product Specification
64
3.14.9.4 Inactivity Timer (Minutes)
Sets how long the computer must be inactive before it enters power managed mode. Enter the
number of minutes. The range is 0 to 255 minutes. The default is 10 minutes.
This field does not appear if APM is disabled.
3.14.9.5 Hot Key (CTRL - ALT-)
Sets the hot key that, when pressed while holding down the <Ctrl> and <Alt> keys, causes the
computer to enter power managed mode. All alphanumeric keys are valid.
This field does not appear if APM is disabled.
3.14.9.6 Auto Start On AC Loss
Enables returning to the last known state of the computer, or powering down upon AC power loss
to the motherboard. The options are:
• Disabled
• • Enabled (default)
3.14.9.7 Power-On COM1 Ring
Enables the computer to power on upon an incoming POTS call to a telephony device configured
for operation on COM1. The options are:
• Disabled (default)
• Enabled
3.14.10 Plug and Play Configuration Subscreen
This section describes the options found on the Plug and Play configuration subscreen.
3.14.10.1 Configuration Mode
Sets how the BIOS gets information about ISA cards that do not have Plug and Play capabilities.
The options are:
• Use BIOS Setup
• Use PnP OS (default)
If Use PnP OS is selected, the BIOS will depend on run-time software to ensure that there are no
conflicts between ISA boards with Plug and Play capabilities and those without. Only the Boot
With PnP OS will be visible.
3.14.10.2 PnP OS
Enables the computer to select the type of PnP OS to boot from. The options are:
• Disabled
• Other PnP OS
• Windows 95 (default)