Filter
Top Products
Motherboard BIOS and Setup Utility
69
3.14.13.4 Set Administrative Password
Sets the Administrative password. The password can be up to seven alphanumeric characters.
3.14.14 Exit Screen
This section describes the different ways to exit and save or not save changes made in the Setup
program.
3.14.14.1 Exit Saving Changes
Saves the changes to CMOS RAM and exits the Setup program. You can also press the <F10> key
anywhere in the Setup program to initiate this.
3.14.14.2 Exit Discarding Changes
Exits the Setup program without saving any changes. This means that any changes made while in
the Setup program are discarded and NOT SAVED. Pressing the <Esc> key in any of the four
main screens initiates this activity.
3.14.14.3 Load Setup Defaults
Resets all of the Setup options to their defaults. You can also press the <F5> key anywhere in the
Setup program to initiate this.
This selection loads the default Setup values from the ROM table.
3.14.14.4 Discard Changes
Discards any changes you made during the current Setup session without exiting the program. You
can also press the <F6> key anywhere in the Setup program to initiate this.
This selection loads the CMOS RAM values that were present when the computer was turned on.