Filter
Top Products
SQ599
49
(2) create new VP.BAT file.
Ventura Setup --- Create New VP.BAT
To create new VP.BAT, please follow the following procedures:
1. In "Install and Setup GEM 3.0 / Ventura 2.0 Drivers" menu,
select "B. Setup Ventura Batch File VP.BAT" to create new Ventura batch file
VP.BAT using new driver. (To select, type "B".)
2. Fom the "Setup Ventura Batch File" screen, keyin the drive letter for the hard
disk where Ventura software resides.
3. From the "Setup Ventura Batch File" menu, choose from
800x600 16 Colors
1024x768 16 Colors
4. After the message
"Are you sure (Y/N) ?"
appears on the screen, keyin
'Y' <Enter>.
5. After setup completes, exit INSTDRV.EXE program.
6. Use new "VP.BAT" to start your Ventura progarm.
5-3-6 PCAD 6.06
Driver Files
1. The enclosed SiS 6205 PCAD drivers (packed files) are
(1) PCAD.1
(2) PCAD.2
(3) PCAD.3
2. Being unpacked, the SiS 6205 PCAD drivers contain the following files:
(1) PSIS800.REX: 800x600 16 Colors
(2) PSIS1K.REX: 1024x768 16 Colors
(3) PSIS12.REX: 1280x1024 16 Colors
3. Use "INSTDRV.EXE" to
(1) unpack and copy drivers to where they should resides,
(2) create new PCADDRV.SYS file.
Setup --- Create New PCADDRV.SYS
To create new PCADDRV.SYS, please follow the following procedures:
1. In "Install and Setup PCAD 6.06 Drivers" menu,
select "B. Setup Configure File PCADDRV.SYS" to create new
PCADDRV.SYS using new driver. (To select, type "B".)