Filter
Top Products
88 Intel® Server System SR2500AL User’s Guide
Replacing the Power Distribution Module
To replace the power distribution module, use the following instructions.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover”.
4. Remove the large air baffle. For instructions, see “Removing the Large Air Baffle”.
5. Remove the fan module assembly. For instructions, see “Replacing a Fan Module”.
6. Disconnect all power cables from the server board, backplane, and mid-plane.
7. Remove the hot-swap power supply/supplies. For instructions, see “Replacing the
Power Supply”.
8. Remove the two screws to release the module (see letter “A”).
9. Lift the module from the server system (see letter “B”).
Figure 78. Removing the Power Distribution Module
10. Set the replacement power supply distribution module into the server system and
screw the module into place.
11. Install the hot-swap power supply/supplies. For instructions, see “Replacing the
Power Supply”.
AF000146
B
A
A