68 Intel® Server System SR2500AL User’s Guide
Installing and Removing the Intel
®
Remote
Management Module and the Intel
®
RMM NIC
Installing the Intel
®
RMM and Intel
®
RMM NIC
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover”.
4. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly”.
5. Squeeze the sides of the Intel
®
RMM NIC module cover to disengage it from the
server system back panel and remove it. See letter “A” in the following figure.
6. A self-adhesive foam gasket is required to protect the underside of the NIC module.
Remove the backing paper from the spacer and install as illustrated (see letter “B”
in the following figure).
7. Attach the standoffs to the server board (see letter “C” in the following figure) and
attach the Intel
®
RMM NIC module to the server board (see letter “D” in the
following figure).
8. Insert the standoff into the hole labeled TH4 on the Intel
®
RMM board (see letter
“E” in the following figure). The standoff installs on the bottom side of the Intel
®
RMM board.