Filter
Top Products
Intel® Server System SR2500AL User’s Guide 31
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord(s).
4. Remove the safety screw if it is installed. See letter "A" in the figure below.
5. While holding in the blue button at the top of the server system in (see letter "B"),
slide the top cover back until it stops (see letter "C").
6. Insert your finger in the notch (see letter “D”) and lift the cover upward to remove
it.
Figure 20. Removing the Server System Cover
Installing the Server System Cover
1. Place the cover over the server system so that the side edges of the cover sit just
inside the server system sidewalls.
2. Slide the cover forward until it clicks into place (see letter “A”).
3. (Optional) Insert the safety screw at the center of the top cover (see letter “B”) if
required.
4. Reconnect all peripheral devices and the AC power cord(s).
TP02127
A
D
C
B