Intel® Server System SR2500AL User’s Guide 99
Figure 89. Installing the Rack Handle
6. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
7. Install the front bezel. For instructions, see “Installing the Front Bezel”.
8. Plug all peripheral devices and the AC power cable(s) into the server.
Removing the Rack Handles
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel if it is installed. For instructions, see “Removing the Front
Bezel”.
4. Remove the server system cover. For instructions, see “Removing the System
Cover”.
5. Remove the two screws holding the rack handle in place, and remove the rack
handle from the server system as shown in the figure below.
AF000019