Filter
Top Products
Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint) 93
Chapter 10—Troubleshooting
Display Messages and LED Indications
Error/Event IRI Error No. Comment
Operational On 0 No error
Out of paper Blink 1005
Next label not found Blink 1031
Label not taken Blink
Out of transfer ribbon Blink 1027
Transfer ribbon is installed Blink 1058
Head lifted Blink 1022
Cutter does not respond Blink 1059
Cutter error1 Blink 1701
Cutter error2 Blink 1702
Cutter error3 Blink 1703
Cutter open Blink 1704
Lss too high Blink 1007
Lss too low Blink 1008
Testfeed not done Blink 1606
Pause Mode entered Blink
Setup Mode entered Blink Including interactive setup from
Fingerprint/Direct Protocol
IP link error Blink See note 1, 2, and 3
IP confi guration error Blink See note 1, 3, and 4
Generic DP error Blink See note 5
Press any key to continue Blink See note 6
Application load error Blink See note 7
IRI blink by application Blink Set by Fingerprint instruction
SYSHEALTH
IRI off by application Off Set by Fingerprint instruction
SYSHEALTH
Application break Off See note 8
Printhead not found Off
Rebooted Off
Inizializing Off Set at startup until operational