Filter
Top Products
128 Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint)
Appendix B—Media Specifi cations
Tickets with Black Mark
⇐ a ⇒ Media Width
Maximum: 114.3 mm (4.50 inches)
Minimum (standard): 25.0 mm (1.00 inches)
Min. (narrow Quick-Load): 40.0 mm (1.57 inches)
Min. (wide Quick-Load): 80.0 mm (3.15 inches)
⇐ b ⇒ Copy Length
Minimum: 20.0 mm (0.8 inches)
Maximum: depends on SDRAM size
⇐ c ⇒ LSS Detection Position
Five fi xed positions, see Chapter 12.
⇐ d ⇒ Black Mark Width
The detectable width of the black mark should be at least 5.0 mm (0.2
inches) on either side of the LSS detection point.
⇐ e ⇒ Black Mark Length
Maximum: 21.3 mm (0.83 inches)
Common: 12.5 mm (0.5 inches)
Minimum: 5.0 mm (0.2 inches)
⇐ f ⇒ Black Mark Y-Position
It is recommended that you place the black mark as close to the front
edge of the ticket as possible and use a negative Stop Adjust value to
control the media feed, so the tickets can be properly torn off.
Media Type Setup
• Ticket (w mark)
Note: Preprint that may interfere with the detection of
the black mark should be avoided. However, the Intermec
Fingerprint statement LBLCOND allows the sensor to be
temporarily disabled during a specifi ed amount of media feed
in order to avoid unintentional detection, see Intermec Finger-
print manuals.
Note: The black mark should be non-refl ective carbon black
on a whitish background. Do not allow any perforations to
break the edge of the media as this may cause the media to split
and jam the printer.