Filter
Top Products
LIST menu, and choose one of the list names there by using the arrow keys and then press the
ENTER key.
In general, when you need to supply the name of a list to a command or a menu, use the LIST
page and the NAMES list.
Choosing Lists to Edit
There are several ways to control which lists are displayed in the Stat List Editor. If you press
the STAT key and then the number 5 key to get to SetUpEditor, you can use that command with
a series of list names separated by columns. For example,
will configure the Stat List Editor to display lists LAA, LBB, and LCC.
As we saw above, if you enter the command SetUpEditor without any list names the Editor goes
back to showing L1–L6 by default. If you are already in the Stat List Editor, you can use the
arrow keys to highlight the names of lists. If you press INS for insert, you can insert new or
existing lists. If you press the DEL key for delete you delete the list from the editor.
This does not erase the contents list. If you wish to do that, highlight the name of the list and
press the CLEAR button and then the ENTER key. This will leave the list name in the editor
and clear its entries.
Deleting Lists
If you store many lists, programs, etc. on your calculator, it is possible that you may start to run
out of memory. If that should happen go into the MEM menu (above the + key) and follow the
sub-menus for deleting items from your calculator. This is one of the few places where the steps
differ between the TI-83, TI-83 Plus, and TI-84 Plus calculators. Just follow the instructions on
the screen.
9