Filter
Top Products
54
Command Table (none of the commands require arguments)
Command name Operation
stat Network information, encoder information and connection information are displayed.
set mode Available modes to select are displayed.
set mode Camera Camera mode is set.
set mode Monitor Monitor mode is set.
set mode Teleconference Teleconference mode is set.
set mode ISMA_Server ISMA Server mode is set.
set mode User_Mode_xxx User more is set. * xxx is the mode name saved by the user.
Example: set mode User_Mode_Camera
(This command is invalid when user mode is not saved.)
set aec Displays on/off of the echo canceller.
Default setting differs depending on the mode.
Teleconference mode: on
Monitor mode: off
Camera mode: off
ISMA Server mode: off (AEC is unavailable)
* Set to off when audio is not used. Disabling echo canceller improves video quality.
* Set to on when the echo canceller is necessary for audio communication.
set aec on Enables the echo canceller.
set aec off Disables the echo canceller.
set tcp Displays whether the transporting of audio and video stream is UDP or TCP.
Default setting is UDP. When setting to TCP, smoother audio and video playback in a
network with low reliability may be achieved.
* In the case of TCP mode, used ports are audio: 49298 and video: 49398. Port settings
in NETWORK SETUP screen are not used. In the UDP mode, used ports are audio:
49200 and video: 49300.
* In the case of RTCP, transmission will be done in UDP even when in TCP mode. When
TCP is selected, used ports for RTCP are audio: 49299 and video: 49399.
* Multicast is UDP protocol. Multicast does not turn to TCP.
set tcp on Switches to TCP mode.
set tcp off Switches to UDP mode.
.set brmon start Displays the output bitrate.
(Not available in the ISMA Server and Monitor modes)
.set brmon stop Disables the output bitrate display.
(Not available in the ISMA Server and Monitor modes)
set mode default Initialize settings of current mode to the factory settings. * Invalid for user mode.
reboot Restarts the unit
ctrl+c or exit Quit the access by terminal software
071:GET IPDISPLAY Shows current setting of IP address display at start
071:SET IPDISPLAY ON Enables IP address display at start
071:SET IPDISPLAY OFF Disables IP address display at start
370: GET DHCPCLIENT Show status of DHCP
371: SET DHCPCLIENT ON Sets to DHCP mode (enabling of this command requires the DM-NC40 to be rebooted
or the power to be turned off and turned back on.)
371:SET DHCPCLIENT OFF Set to Manual mode (enabling of this command requires the DM-NC40 to be rebooted
or the power to be turned off and turned back on.)
For details concerning other commands, contact the nearest JVC-authorized service agent.
Settings Using the Terminal Software of a PC
(Continued)