Filter
Top Products
8
Names and Operations of Parts
1
[POWER] Power button and display lamp
Turns the unit power on and off.
Press securely until a click is heard.
The display lamp turns green when the power is on.
2
[PinP] Picture-in-Picture button
When in the Monitor mode,
pressing the button on the
monitoring side will light the
button and display 2 videos in-
putted to the camera side as
shown on the right.
When pressing the
3
SELECT
button during PinP display, the
displayed videos will switch.
When in the Teleconference
mode, videos of both sides are
displayed as shown on the
right.
3
[SELECT IN 1, IN 2] Select
button and display lamps
Selects the input signal between VIDEO IN 1 and VIDEO
IN 2. When in the Monitor mode, pressing the button on the
monitoring side select input videos to camera side. Press-
ing the button on the camera side select input videos to
camera side.
When in the Teleconference mode, pressing the button
select input videos to own side.
4
[HOLD] Operation lock button and display lamp
Pressing the button for 3 seconds or more will light the
display lamp and button operations other than the
1
[POWER] button will be locked. Pressing the button
again for 3 seconds or more while the lamp is on will
cancel the lock and the lamp will turn off.
(Factory setting: HOLD)
5
[STOP] Stop button
Pressing the button will terminate connection and the
0
connection number display will turn off.
(
੬ See “Operations”, pages 42 and 43)
6
[PLAY] Play button
Pressing the button will establish connection. The con-
necting destination will be displayed in the
0
connec-
tion number display.
(
੬ See “Operations”, page 42)
7
[CF] Compact Flash button
The button will light when a CF (Compact Flash) card
is inserted in the
A
CF card slot. During the Monitor
mode, recording can be made on the camera side.
Pressing this button while the lamp is on will start im-
age recording and the lamp will flash. While recording
is in progress, pressing the button again will stop re-
cording.
(
੬ See “About the Alarm”, page 56)
8
[ENCODE, DECODE] Encode and decode display
lamps
Displays the operation status of the unit.
When the ENCODE lamp is on, the unit is operating as
an encoder.
When the DECODE lamp is on, the unit is operating as
a decoder. When both lamps are on, the unit is operat-
ing as a codec.
9
Number Select buttons
Used when selecting a connecting destination. The cur-
rently selected digit will be indicated using a flashing
display.
• Press ̇ or ̈ to select the digit.
• Press ̄ or ̆ to increase or decrease the value of the
selected digit.
Front
POWERIN 2IN 1HOLDDECODEENCODE
CF PLAY STOP HOLD SELECT P Pin
!0 u
q
wetryio
!1
Teleconference mode
(Other party)
(User)
Monitor mode
(VIDEO1)
(VIDEO2)