JVC DT-V1710CG Computer Monitor User Manual


 
20
HOW TO USE SETUP MENU (cont'd)
CONTRAST
•–20 ~ 00 ~ +20
BRIGHT
•–20 ~ 00 ~ +20
CHROMA
•–20 ~ 00 ~ +20
PHASE
•–20 ~ 00 ~ +20
NTSC SETUP
Sets the set-up level of the input NTSC signal.
00 : Compliant with 0% set-up signal.
7.5 : Compliant with 7.5% set-up signal.
NOTE :
NTSC SETUP is displayed only when the video input card is
installed and an NTSC signal is input.
COMPO. LEVEL
Sets the set-up level of the input component signal.
SMPTE : Compliant with M2VTR signals.
B75 : Compliant with Betacam 7.5% set-up signal.
B00 : Compliant with Betacam 0% set-up signal.
NOTE :
COMPO. LEVEL is displayed only when a 480/60i, 480/60p, 576/
50i or 576/50p signal is input.
<COLOR TEMP./BAL.>
COLOR TEMP. :LOW
BLUE DRIVE : 000
RED DRIVE : 000
GREEN CUTOFF : 000
BLUE CUTOFF : 000
RED CUTOFF : 000
sub menu
reset
EXIT:
MENU
ADJUST:- + SELECT:
COLOR TEMP./BAL.
Sets or adjusts the colour temperature or white
balance.
Press the button to
display the setting menu
illustrated on the right.
Use the five items indicated with
mark to make fine adjustments
between the monitors.
COLOR TEMP.
Selects the colour temperature.
HIGH : Sets the colour temperature to 9300.
LOW : Sets the colour temperature to 6500.
BLUE DRIVE
Adjusts the blue drive level.
MIN ~ 000 ~ MAX (in 127 grades)
RED DRIVE
Adjusts the red drive level.
MIN ~ 000 ~ MAX (in 127 grades)
GREEN CUTOFF
Sets the green cut-off point.
MIN ~ 000 ~ MAX (in 205 grades)
BLUE CUTOFF
Sets the blue cut-off point.
MIN ~ 000 ~ MAX (in 205 grades)
RED CUTOFF
Sets the red cut-off point.
MIN ~ 000 ~ MAX (in 205 grades)
<PICTURE SUB ADJ.>
CONTRAST : 00
BRIGHT : 00
CHROMA : 00
PHASE : 00
NTSC SETUP : 00
COMPO.LEVEL :SMPTE
sub menu
reset
EXIT:
MENU
ADJUST:- + SELECT:
PICTURE SUB ADJ.
Controls the approximate adjustment of the video
control level when the video adjustment knob is
adjusted to the centre.
Can also be used to switch the NTSC set-up level, and
change the component signals input level settings.
Press the button to
display the setting menu
illustrated on the right.
NOTE :
When the RGB signal is input, only
CONTRAST and BRIGHT are
displayed. When the PAL signal is
input, only CONTRAST, BRIGHT
and CHROMA are displayed.
LCT1423-001A_p18-32 4/29/03, 5:08 PM20