JVC GV-PT2 Printer User Manual


 
EN 11
PREPARATION OF THE REMOTE CONTROL (RC) UNIT
How to aim the remote control
unit
How to install the batteries
Place two R6 batteries in the
compartment. Align the batteries as
shown.
Operating distance
depends on the ambient
brightness and the angle
at which the RC unit is
aimed at the receiver.
When replacing the batteries
Use two R6 batteries.
Replace both batteries at the same time. Do
not mix new batteries with used batteries.
Insert the batteries in accordance with the +
and – indications.
Be sure to read the precautions on the
battery label.
Approx.
30°
Remote control
signal receiver
Within 5 m
Notes on the batteries
Remove the batteries from the RC unit when
not using it for a long period.
If the RC unit does not work properly,
remove the batteries from the unit and let it
stand for a while, then replace the batteries
and try using it again.
When to replace the batteries:
When the remote control’s operating
distance starts to decrease, it means that the
battery level is dropping. In this case,
replace the batteries with new ones.