Filter
Top Products
58
M.CH
CW
AGC AUTO
M.CH
USB PRG
AGC AUTO
M.CH
FSK
AGC AUTO
M.CH
USB PRG
AGC AUTO
M.CH
M. SCR PRG
AGC AUTO
M.CH
USB M. SCR
AGC AUTO
USB
AGC AUTO
USB
AGC AUTO
9 MEMORY FEATURES
STORING SCAN LIMITS IN CH 99
Although the Scan function is discussed fully in the next
chapter, here you will learn how to store the frequency
limits that must be saved first before Scan can be used.
1 Select the Start frequency limit and mode using
VFO A.
• This frequency can also be used for receiving
and transmitting after completion of this
procedure.
2 Select the End frequency limit using VFO B.
3 Press [RX A].
4 Press [M.IN] to select the Memory Scroll mode.
•To exit from Memory Scroll mode and abort the
storage process, press [CLR].
5 Turn the M.CH/VFO.CH control to select channel 99.
6 Press [M.IN] to store the frequency limits.
•Pressing [M.IN] overwrites new data on any
previous data in that channel.
Note:
On some General market versions, the frequency limits must
be on the same band or they cannot be stored.
■ Confirming Start/End Frequencies
The following allows you to check the programmed
Start and End frequencies.
1 Press [RX M.CH] to select Memory Recall mode.
2 Turn the M.CH/VFO.CH control to select
channel 99.
3 Press [DOWN] to check the Start frequency and
press [UP] to check the End frequency.
■ Programmable VFO Function
This function restricts the range of the Tuning
control to those frequencies included by the Start
and End frequencies that were programmed above.
One application of this function is to keep your
operating within the authorized frequency limits of
your license.
1 Press [RX M.CH] to select Memory Recall mode.
2 Turn the M.CH/VFO.CH control to select
channel 99.
3 Turn the Tuning control and you will notice that
you can only tune from the Start frequency to the
End frequency. After reaching the End frequency,
the transceiver reverts back to the Start
frequency again.