Filter
Top Products
Troubleshooting
2-2 March 2001
Calibration Errors
Numeric Calibration Error Codes
Code Status Message Possible Cause/Subsystem Possible Solution
1 The following file is
locked:_filename_.
The system is trying to access a
file that is currently in use.
Close any other applications that
may be accessing the file.
2 The following file is
protected:_filename_.
The system is trying to access a
protected file.
Change the protections on the file
to grant access to the user.
3 The following file was not
found:_filename_.
The system was trying to access
a file that it could not find.
Verify that the filename on one of
the configuration dialog windows is
correct.
4 Error:_oserror_occurred
during operation:_operation_
on file:_filename_.
An operating system error
occurred.
• Rerun the application.
• Reboot the operating system
5 The following file is in an
incorrect format:_filename_.
The file does not conform to the
application specification.
Verify the file format.
6 The following file already
exists:_filename_.
The system is trying to save to a
file that already exists.
• Delete the existing file.
• Change the filename.
7 There is not enough space to
create:_filename_.
The system is trying to save a file
but there is not enough disk
space.
Remove any unnecessary files to
increase free disk space.
8 There are too many files to
open _filename_.
Too many files are open. Close some files and or
applications.
9 You do not have permission
to open file _filename_.
The file permission is invalid. Rerun the application.
10 Error copying print LUT to
DP2 folder (can’t open
_filename_.
The folder doesn’t exist or is read-
only.
Modify the protection on the folder.