Kodak 6B6640 Printer User Manual


 
Troubleshooting
March 2001 2-5
117 A software error has been
detected by the following
device: _devicename_ Error
Message: _errmsg_
An error has occurred on the
printer.
Resolve printer error condition.
118 A SCSI ID for the following
device was not found:
_devicename_.
SCSI driver not found. Reinstall the SCSI driver on host
computer.
119 The wrong SCSI ID was
specified for the following
device: _devicename_.
SCSI ID is incorrect. Set the Target SCSI ID to the
printer SCSI ID.
120 This device has been setup
for the wrong model of
printer: _devicename_.
The chosen device has not been
found.
Verify chosen device matches the
printer model.
121 Unable to read STATUS from
device: _devicename_.
Unable to see the printer. Check SCSI cable connections.
122 The selected LUT contains
data that exceeds the limits
of this printer.
Trying to send a 12-bit LUT to a
10-bit printer.
Select a 10-bit LUT file.
201 An error occurred while
trying to allocate memory.
The system is trying to allocate
memory; however, no memory is
available.
Close any unnecessary
applications.
202 The following parameter is
invalid:_parametername:
_parametervalue_.
An internal error occurred with the
software.
Restart the application.
If problem continues, call for
service.
203 The function is not supported
by the class.
An internal error occurred with the
software.
Restart the application.
If problem continues, call for
service.
204 This function has not been
implemented.
An internal error occurred with the
software.
Restart the application.
If problem continues, call for
service.
Code Status Message Possible Cause/Subsystem Possible Solution