Filter
Top Products
22 KODAK EKTAGRAPHIC III Slide Projector
Maintenance
Changing the Projection Lamp
Slide the power switch to Off and unplug the projector.
Allow the projector and lamp
to cool for about 10 minutes.
Push the lamp-module
release button and remove
the lamp module. You can
replace it with a new lamp
module or replace only the
lamp.
Note: There is an additional
safety latch, which reduces
the chance of an accident
with a loosely inserted lamp
module, that may cause some
resistance. To release the
latch, you may need to apply
extra effort when you pull out
the module.
To replace only the lamp, lift up the lamp release clip. Carefully remove the
worn lamp from the socket and place it on a heat-resistant surface.
Insert a new lamp into the
socket. Push down to tightly
seat the replacement lamp.
Relatch the clip in the forward
position and push the lamp
module all the way back into
the projector until it latches.