Filter
Top Products
A-61517 October 2004 4-17
Camera settings area
The selections in the Camera area list the available sides (front and
back) of an image where you can define individual image processing
values. For more information about the Camera selections see the
section entitled, “Image outputs” in Chapter 1.
When starting the configuration process, use the steps below as a
guide:
1. Check the images you wish to capture (Enable camera settings).
2. Select the order to transfer the images (Define Transfer Order).
3. Configure each image by highlighting it (Configure).
Enable camera settings select the desired checkbox to enable the
Front Color, Front Binary, Back Color or Back Binary settings as desired.
This indicates the images you wish to capture and transfer to the host.
(It is possible to capture only rear images.) You can enable your
selection by putting a checkmark in the desired box.
Define Transfer Order define the transfer order by selecting the
Color First or Binary First radio button. This determines which image
is transferred to the host first when using simultaneous output scanning.
For example, if you are scanning front color and front binary and you
select Binary First the scanner will return the front binary image, then
the front color image.
Configure highlight the image you want to setup. As you select the
image, other options will become available on the Scanner Settings
dialog box. The availability of these options is dependent upon the
selection you make.
For example, Front Binary is highlighted in the example to the left.
Convert Color to Grayscale this option is only available when
configuring color cameras. When selected, the scanner will convert the
color image data to grayscale before making it available to the host.
Scan Source the host computer provides information to the scanner
defining whether to scan one or both sides of the document. Simplex
indicates that only one side (front side) of the document will be scanned.
Simplex – Back indicates that only one side (rear side) of the document
will be scanned. Duplex indicates that both sides of the document will
be scanned.
ADF select this option when using the scanner in continuous feed
mode.