Filter
Top Products
A-61517 October 2004 2-2
Scanner setup
To setup the scanner:
1. Setup your scanner operating conditions:
• simplex/duplex
• image order
• transport timeout
• transport timeout response
• length detection status and response
• multi-feed detection status and response
• page-on-demand or batch count mode
• starting document count
• Energy Star timeout
• confirmation tone
For information on programming these conditions, see Chapters
3 or 4 (depending on your driver). For other vendor tool kits, refer
to their documentation.
2. Select your color table as appropriate for color document
scanning. See Chapters 3 or 4 (depending on your driver). For
other vendor tool kits, refer to their documentation.
3. Determine if any changes to the Image Processing parameters
need to be made for the current application.
NOTE: This check needs to occur for up to four separate images
from the six available options depending on your
application: Front Color, Front Bi-tonal, Front Grayscale,
Rear Color, Rear Bi-tonal, Rear Grayscale.
Image Processing parameter changes remain in effect until one
of the following conditions occur:
• The scanner is powered down using the power switch.
• New imaging parameters are sent from the host.
4. Prepare documents according to the instructions found in the
Kodak i100 Series Scanners, User’s Guide.