Filter
Top Products
Conveyance Section Main Unit Theory of Operation
2-90
II Composition/Operation
15.3.5 Control of loop formed before fusing section
• The difference between the fusing speed and media conveyance speed is corrected to
prevent double transferred images and brush effects from occurring.
• The Paper Loop Sensor (PC6) detects the length of the loop formed in the media
between the 2nd Transfer Roller and the Fusing Pressure Roller. The fusing speed is
then varied according to the length of the loop detected. By varying the fusing speed, any
effects from the Fusing Pressure Roller side (part-to-part variations, change of parts over
time) are prevented from being transferred to the 2nd transfer section.
• No loop control is provided to perform the fusing process at high speeds when envelopes
are used (to prevent wrinkles).
☞ 2-100
• Fusing deceleration (low speed):
When the media loop length is small, the actuator of the Paper Loop Sensor (PC6) is
pushed up a small amount and the sensor is unblocked. When the sensor is unblocked,
the fusing speed is decelerated (-1.36%).
• Fusing acceleration (high speed):
When the media loop length is large, the actuator of the Paper Loop Sensor (PC6) is
pushed up a large amount and the sensor is blocked. When the sensor is blocked, the
fusing speed is accelerated (+1.64%).
4138to2069c1
4138to2069c2
Fusing Pressure
Roller
2nd Transfer Roller
Paper Loop Sensor
Actuator
Fusing deceleration Fusing acceleration
5430DL_5440DL_5450_TO_PDF.book 90 ページ ２００５年４月１２日 火曜日 午後４時４９分