Filter
Top Products
11: Service Settings
EDS User Guide 84
Syslog Settings
The Syslog web page shows the current configuration and statistics of the system log.
To configure the Syslog:
Note: The syslog file is always saved to local storage, but it is not retained through
reboots. Saving the syslog file to a server that supports remote logging services (see RFC
3164) allows the administrator to save the complete syslog history. The default port is 514.
1. Select Syslog on the menu bar. The Syslog page opens to display the current configuration.
Figure 11-8 Syslog
2. Enter or modify the following settings:
Table 11-9 Syslog
3. Click Submit.
Syslog Settings Description
State Select to enable or disable the syslog.
Host Enter the IP address of the remote server to which system logs are sent
for storage.
Local Port Enter the number of the local port on the device from which system logs
are sent.
Remote Port Enter the number of the port on the remote server that supports logging
services. The default is 514.
Severity Log Level From the drop-down box, select the minimum level of system message
the device should log. This setting applies to all syslog facilities. The
drop-down list is in descending order of severity (e.g., Emergency is
more severe than Alert.)