Filter
Top Products
Installing the Ni-Cd Battery Pack
To use the battery pack, follow these steps:
1 Make sure that the power switch of the CD-ROM drive is off.
2 Open the battery cover by gently pushing the two protruding
clips as shown.
3 Slide the battery pack into the drive.
The positive end (+) of each battery has a protrusion. This end
should be opposite the springs.
Attention
Do not insert the battery pack into the CD-ROM drive with
the polarity reversed.
Install the battery pack with the label facing upward. To allow
for later easy removal of the battery pack, extend the ribbon
below the battery pack. To remove the battery pack, lift the
ribbon.
2-8 20X Max Portable CD-ROM Drive