Filter
Top Products
57
USB Device Information: You can set printer names and
display some information of USB mass storages and scanners.
Please refer to Chapter 4, Chapter 6 and Chapter 7.
TCP/IP: You have to set the server’s TCP/IP configuration to
connect TCP/IP network. Please see Chapter 3 Basic
Installation for more details.
Supported Protocols: The server supports the following
TCP/IP protocols:
TCP/IP
Enable LPR (Line Printer Remote) Printing: select or
clear Enable LPR Printing support. It is enabled in
Factory Default.
Enable IPP Printing: select or clear Enable IPP
Printing support. It is enabled in Factory Default.
Enable Raw TCP Printing: select or clear Enable Raw
TCP Printing support. It is enabled in Factory Default
and users may set the protocol’s TCP ports as
following boxes:
- TCP Port 1: set TCP port for the printer of USB1 port
(default: 9100)
- TCP Port 2: set TCP port for the printer of USB2 port
(default: 9101)
Enable SMB (Server Message Block) Print/File Server:
select or clear Enable SMB Print/File Server
support. It is enabled in Factory Default.
Enable FTP Server: select or clear Enable FTP
Server support. It is enabled in Factory Default and
users may set some parameters as follows:
- FTP Port: type an integer number to set FTP
server’s TCP port (default: 21)
- Set Maximum Session Number: select or clear Set
Maximum Session Number support. You can
limit the FTP session number by selecting the
support and type an integer to set the allowable
maximum session number. If you clear the support,
it means that FTP server will have not any limitation