Filter
Top Products
7
2.3.1 Ethernet Connector
The network connector of FPS-3003 is designed for 10 Mbps or 100
Mbps Ethernet networks and connects to the network via a twisted
pair category 5 cable (10baseT and 100baseTX) or better.
2.3.2 USB Host Ports
FPS-3003 has two USB host ports which are USB 1.1/2.0 low and full
speed compliant and successfully tested with USB 1.1/2.0 printers,
Mass Storage and HP Office Jet series printers (MFP).
2.3.3 Init Button
The Init button is used for:
printing a page of configuration report to check the connection
to the printer and showing the MFP server settings
performing a Factory Default of the MFP server, which will
restore most of the parameters and settings to factory default
values
performing the new firmware upgrade using in fallback
2.3.4 Indicators
Power Indicator is lit while power is applied. If it is not lit, or if
it blinks, there is a problem with MFP server or Power Adapter.
Link Status is lit while network is applied. If it is not lit, it
indicates that the server does not connect to network.
Status Indicator blinks to indicate network activity.
USB1 Indicator is lit while an USB device connects to USB1
Port of MFP server. If it is not lit, or if it blinks, there is a
problem with the USB device or the MFP server.
USB2 Indicator is lit while an USB device connects to USB2
Port of the MFP server. If it is not lit, or if it blinks, there is a
problem with the USB device or the MFP server.