Filter
Top Products
113
33
Resetting the maintenance counter
After replacing the fuser or transfer belt, you must reset the maintenance counter.
If the message Did you replace Fuser? or Did you replace Belt? appears, press
Go.
Otherwise, use the following steps to reset the fuser or transfer belt counter.
Note: Although the fuser is shown, the same procedure is used to clear the transfer belt.
1 Press Menu until Supplies Menu appears on the second line of the display.
2 Press Select to open the Supplies Menu.
3 Press Menu until Replace Supplies appears on the second line of the display.
4 Press Select to open Replace Supplies.
1
Menu
2
Select
3
Go
5
Return
4
Stop
6
SUPPLIES MENU
1
Menu
2
Select
3
Go
5
Return
4
Stop
6
SUPPLIES MENU
REPLACE SUPPLIES