Filter
Top Products
129 128
Printer prints blank pages
Symptom: MASTERFORM prints out extra blank
pages.
Cause: Your margin settings are set too high.
If your margin settings are higher than the recom-
mended settings (see page 107), the program
may print additional blank pages.
Resolution/Workaround: To change your margin
settings, complete all package information in the
form-fill wizard as you would for generating a new
package. When you arrive at the print preview,
select Page Setup from the file menu.
After you have changed all four margins to the
recommended settings listed on page 107, go
back into Page Setup again under the file menu
to verify that the program saved your changes.
If your margins revert from what you changed
them to, your printer driver may not support a
margin setting small enough. To correct this
problem, you can try installing an alternative
driver by following the directions listed below:
1. Double-click the Add Printer icon in the
Printers window
2. Follow the instructions in the Add Printer
wizard. Choose HP from the list of printer
manufacturers and select the HP LaserJet
III driver from the list.
3. When done, select the correct printer
driver in MasterForm from clicking on the
Page tab from the Page Setup screen in
MasterForm. Click on Use Specific Printer,
and click the Printer button to select your
HP LaserJet III driver from the list, then
click on the Margins tab again to change
margins back to the recommended settings
on each side by following the directions
above.
Laser forms are not lining up properly
Symptom: When you print on the UPS laser
shipping form, the information does not line up
properly.
Cause: Your margins may not be set properly,
and/or the fields on the form may be adjusted to
print well on your printer.
Resolution/Workaround: For information on how
to adjust the margins, see the chapter entitled
Setting the Margins.
To adjust specific fields on the form, you will need
to use the Nudge tool. You can find instructions
on how to use the Nudge tool in the section titled
Moving fields on the form: use the Nudge tool.