Filter
Top Products
Chapter 3
Advanced Configuration
16
Wireless-N ADSL2+ Gateway
26 hexadecimal characters in length. Valid hexadecimal
characters are “0”-“9” and “A”-“F”.
TX Key. To indicate which WEP key to use, select a default
Transmit (TX) Key number.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes.
WEP (May affect wireless performance. WPA2 recommend-
ed)
Security Mode > WEP
Encryption Select a level of WEP encryption, 64-bit or
128-bit.
Passphrase Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
NOTE: The WEP Passphrase is compatible with
Linksys wireless products only. If you are use non-
Linksys products, manually enter the appropriate
WEP key on those devices.
WEP Key 1-4 If you did not enter a Passphrase, enter the
WEP key(s) manually.
TX Key Select which TX (Transmit) Key to use. The default
is 1.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes.
Wireless > Wireless Mac Filter
Wireless access can be filtered by using the MAC addresses
of the wireless devices transmitting within your network’s
radius.
Wireless > Wireless MAC Filter
Wireless MAC Filter
To filter wireless users by MAC Address, either permitting
or blocking access, click Enabled. If you do not wish to
filter users by MAC Address, select Disabled.
Access Restrictions
Block. Click this button to block wireless access from the
devices listed on this screen.
Permit. Click this button to allow wireless access by the
devices listed on this screen.
MAC Address Filter List
Click the Wireless Client List button to display the Wireless
Client List. It shows computers and other devices on the
wireless network. The list can be sorted by Client Name,
Interface, IP address, MAC Address, and Status. Click the
Add to MAC Filter List checkbox for any device you want
to add to the MAC Address Filter List. Then click the Add
button. To retrieve the most up-to-date information, click
the Refresh button. To exit this screen and return to the
Wireless MAC Filter screen, click the Close button.