Filter
Top Products
EtherFast Cable/DSL Routers
4. Connect the power-supply cable to the Power port on the rear of the
Router, then plug the supplied AC power cable into a power outlet. Plug the
other end into the back of the power adapter.
• The Power LED will illuminate green as soon as the power adapter is
connected.
• The Diag LED will illuminate red for a few seconds while the Router
goes through its internal diagnostic test. The LED will turn off when the
self-test is complete.
5. Power on the Cable or DSL modem.
6. Press the Reset button on the front of the router. Hold the button in for
three seconds, or until the Diag LED illuminates red. This restores the
router’s default settings.
The Hardware Installation is complete. Continue to the next page to con-
figure the router’s settings.
11
BEFSR41 User Guide Apr 2000.qxd 4/27/00 3:20 PM Page 11