Filter
Top Products
50
Chapter 5: Setting Up and Configuring the Router
VPN Tab - Client to Gateway
10/100 8-Port VPN Router
Dynamic IP + E-mail Addr.(USER FQDN) Authentication: This setting uses a dynamic IP address, which is
constantly changing. In addition, the tunnel is confirmed through use of an email address. Only one email
address can be used for one tunnel and may not be applied to another tunnel.These settings must match the
Remote Group Setup on the other end of the tunnel.
Remote Security Group Type. Select the local LAN user(s) that can use this VPN tunnel. Remote Security Group
Type may be a single IP address, a Subnet or an IP address range. The Remote Secure Group must match the
Local Secure Group on the other end of the tunnel. Selecting IP Address allows only one computer, with the
specific IP Address, access to the tunnel. (The default IP is 192.168.1.0.) If you select Subnet, all computers on
the local subnet can access the tunnel. The default IP is 192.168.1.0, and default Subnet Mask is
255.255.255.192. If you select IP Range, you can specify a range of IP Addresses to access the tunnel. The
default IP Range is 192.168.1.0~254.
With Group VPN enabled:
Further Remote Client Setup options become available when you select GroupVPN. There are three types of
Remote Client: Domain Name (FQDN), E-mail Address (User FQDN), and Microsoft XP/2000 VPN Client.
Domain Name (FQDN) (Fully Qualified Domain Name): Enter the Domain Name of the Remote Client. When the
Remote Client requests to create a tunnel with the Router, the Router will act as a responder. The Domain Name
must match the local settings of the Remote Client.
E-mail Address (User FQDN): Enter the Email Address of the Remote Client. When the Remote Client requests to
create a tunnel with the Router, the Router will act as a responder. The Email Address must match the local
settings of the Remote Client.
Microsoft XP/2000 VPN Client: This option is used for Dynamic IP users (e.g. PPPoE or DHCP) which using
Microsoft VPN client. The difference between Microsoft and other VPN client is that Microsoft client does not
support Aggressive mode and FQDN/USER FQDN ID options.
IPSec Setup
In order for any encryption to occur, the two ends of the tunnel must agree on the type of encryption and the way
the data will be decrypted. This is done by sharing a “key” to the encryption code. There are two Keying Modes of
key management, Manual and IKE with Preshared Key (automatic). If GroupVPN is enabled, the key management
will be IKE with Preshared Key only.