Filter
Top Products
Configuration
2-2 Issue 1 June 1998
■
Each password begins with two digits (00–99). The 00
password is reserved for the system administrator and can be
used to change any of the remaining passwords.
Programming the Switch
Module
The Switch Module can be programmed using a terminal or while
online from the Disconnect Menu of the remote telephone, if logged
on as the System Administrator..
The following Switch Module features can be programmed or viewed
from the PC terminal:
■ Passwords
■ PBX COM Port Settings
■ Show Settings
■ Additional Modem Initialization
■ Software Upgrade
*
When configuring the Switch Module, ensure the PC or terminal
has its communications parameters set to 9600 bps, No parity, 8
bits and 1 stop bit.
*
For information about this feature, please contact your Lucent
representative.