Filter
Top Products
Log In
5-2 INA Module Installation and Configuration Guide
Using a Telnet Session
Once the INA module has been connected to a network and an Ethernet address has
been assigned, Telnet is the best way to establish a console session.
1. Run a Telnet application from a network connected workstation.
2. Select the connect function, and enter the IP address assigned to the INA
module’s Ethernet port.
3. Press Enter if needed.
A login prompt appears.
Using the Passthrough Serial Connection
1. Make sure that the serial passthrough cable has been connected to the INA
module and the MERLN MAGIX processor module.
See “Connect a Serial Passthrough Cable” on page 3-1.
2. Use the MERLIN MAGIX WinSPM application on a PC workstation with a
modem to dial up a connection to the MERLN MAGIX processor module.
Connect to *10 to access the modem.
3. Enter your MERLIN MAGIX system administration password and select
the WinSPM Passthrough option.
4. Press Enter to receive a login prompt to the command line interface of the
router.
Log In
Follow these steps to log in to the INA module:
1. At the login prompt, type !root and press Enter.
2. At the password prompt, press Enter—no password is needed for a
first-time installation.
login: !root
Password:
Command>
Set the Administrative Password
The password is an ASCII-printable string of up to 16 characters used to access the INA
module administrative features. Only a person with administrative access can change
this password.
Enter the following commands to set the password: