Selecting PMVision Functions
6-6 INA Module Installation and Configuration Guide
Ether0 netmask INA→Configure→Ethernets,
Edit
IP netmask
System name INA→Configure→SNMP System name
Default gateway INA→Configure→Global IP gateway
Name service type INA→Configure→Global Name service
Name server address INA→Configure→Global Primary name server
WAN port address INA→Configure→Ports, Sync
ports, Edit
Local IP address
Remote router address INA→Configure→Ports, Sync
ports, Edit
DestinationIP
address
Remote router
netmask
INA→Configure→Ports, Sync
ports, Edit
Netmask
Channel rate INA→Configure→Lines,
line0,→Edit→Groups→Edit
Rate, Save
Protocol INA→Configure→Ports, Sync
ports, Edit
PPP or Frame
DLCI list source
(Frame Relay only)
INA→Configure→Ports, Sync
ports, Edit
Keep Alive
LMI, Annex-D or
manual
DLCI Keepalive Value
(Frame Relay only)
INA→Configure→Ports, Sync
ports, Edit
Keepalive interval
DLCI list (Frame Relay
only)
DLCI number, IP
address
DHCP server address INA→Configure→DHCP Select the checkbox
to enable
DHCP lease time INA→Configure→DHCP Lease
DHCP static binding IP
addresses and
corresponding MAC
addresses
INA→Configure→DHCP→
Bindings→Add
IP address, MAC
address
DHCP address pool
start address and end
address
INA→Configure→DHCP IP pool addresses
Table 6-1 Basic INA Module Configuration Using PMVision (Continued)
Setting Select PMVision Function: Entry