Filter
Top Products
Communication 5
Lucent Technologies Model 3000 UPS Operator's Manual (167Ć405Ć119 Issue 3)
47
3 Press and hold the Output Off button a second time until the alarm
beeps again.
A single indicator, corresponding with the current setting, remains
flashing.
4 Press the Output Off button to scroll through the communication
options, top to bottom. Each time you press the button, the UPS beeps and
the next indicator flashes.
NOTE If you do not save a selection within two minutes, the setup automatically aborts
and switches back to the original configuration.
5 Press and hold the Output On button until the alarm beeps to select and
save a communication option. Failure to release the button immediately
after the beep will cause the UPS to abort the setup.
6 Press the Output On button again to return the UPS to Normal Mode.
NOTE Printer Mode selections are the only serial communication modes available from
the front panel.
UPS Serial Communications Menu
With the UPS Serial Communications (Main) Menu, you can view or select UPS
communication modes, baud rates, and LAN configurations. To change or display
the current communications configuration:
1 Connect the UPS serial port to a video monitor with a serial interface or to
your computer's serial port. If you are using shutdown software, the UPS
should already be connected to your computer.
2 Set your terminal so that it matches the baud rate of the UPS (usually
2400 baud, 8 bits, No parity, 1 stop bit). Refer to your terminal or
operating system documentation for details on configuring your terminal
communication settings.
3 At the terminal prompt, press
Control-C until the UPS Serial
Communications Menu appears.
i
i