Filter
Top Products
9-8
■ Assembly of the LCD
LCD Refrection Sheet
Holder Sheet
Holder Sheet
LCD Refrection
Sheet
LCD Refrection
Sheet
Prism Sheet
LIGT GUIDE
PANEL
LCD
FRAME
0~0.5mm
Insert after attaching 1.
Make the silver side inside.
Insert into the inside the ribs.
(4 places in total)
To avoid deflection,
do not attach 2 too
close to the Frame.
Positional Relation Chart for 1 and 2
Avoid running over the rib.
(both sides)
(Running over causes moire.)
Insert into the inside the Hooks.
(both sides)
LCD Module
Light Shield Sheet A
Light Shield Sheet A
Light Shield Sheet A
Light
Shield
Sheet A
AR SHEET
MODULE
LCD FRAME
LCD
LCD
NG
OK
0.5~0mm
0.50
~0mm
0~0.3mm
Notes for removing the Protection Films.
*Remove it parallel to LCD.
Protection Film
Protection Film
ion-
blower
ion-
blower
Before reattaching the peeled
Protection Film to the LCD,
remove electricity.
*Absolutely avoid any
stress on FPC.
Handle with care.
Details for attachment
Do not bend in the
arrow direction.
Avoid running over AR SHEET.
After removing the four sheets of the
Release Paper of the two-sided tape
on the LCD frame, then attach 1.
Remove the Protection Films. (both sides)
Peeled Laminate Film is electric-charged.
Before reusing the Film, remove electricity.
Safety Working
<To prevent damage to DBEF layer and
static electricity generation>
When removing the back side (inside)
Protection Film,keep the wind from the
ion-blower to the peeled side of LCD.
Then remove the Film slowly spending
more than five seconds, from LCD TAB
side on the left bottom toward along the
arrow direction.