Filter
Top Products
WINDOWS MME AUDIO INPUT DEVICES: All Delta 1010LT analog and S/PDIF
inputs may be used simultaneously for a total of 10 input channels. Within your software
application(s), the names of the Delta 1010LT audio input devices are:
PCM In 1/2 Delta-1010LT
PCM In 3/4 Delta-1010LT
PCM In 5/6 Delta-1010LT
PCM In 7/8 Delta-1010LT
S/PDIF In Delta-1010LT
Mon. Mixer Delta-1010LT
The PCM In devices allow recording a stereo stream directly from the specified analog
input pairs. The S/PDIF In device allows you to record a stereo stream directly from the
S/PDIF input. The Mon. Mixer device allows stereo recording from the digital "monitor"
mixer built-into the Delta 1010LT. The audio data recorded from this device is the mix of
input and output streams that is set up in the Delta Control Panel software’s Monitor
Mixer page (see Delta 1010LT Control Panel Software section).
Note that all of the input devices are stereo. Your application software may break these down
further to "left" and "right" mono devices. Therefore you may see them as "Left PCM In 1/2
Delta-1010LT, Right PCM In 1/2 Delta-1010LT," "Left S/PDIF In Delta-1010LT, Right S/PDIF
In Delta-1010LT," or "Left Mon. Mixer Delta-1010LT, Right Mon. Mixer Delta-1010LT," etc.
from within your recording software.
WINDOWS MME AUDIO OUTPUT DEVICES: All Delta 1010LT analog and S/PDIF
outputs may be used simultaneously for a total of 10 output channels. Within your
software application(s), the names of the Delta 1010LT audio output devices are:
WavOut 1/2 Delta-1010LT
WavOut 3/4 Delta-1010LT
WavOut 5/6 Delta-1010LT
WavOut 7/8 Delta-1010LT
WavOut S/PDIF Delta-1010LT
All WavOut devices allow playing a stereo audio stream to the analog hardware outputs (for
WavOut 1/2, 3/4, 5/6, 7/8), the S/PDIF hardware output (for WavOut S/PDIF), and/or into the
hardware router or mixer. Your application software may break each of these stereo devices
down further to "left" and "right" mono devices. Therefore you may see them as "Left
WavOut 1/2 Delta-1010LT, Right WavOut 1/2 Delta-1010LT", or "Left WavOut S/PDIF
Delta-1010LT, Right WavOut S/PDIF Delta-1010LT", etc. from within your music software.
Other software will handle the outputs as stereo pairs, but allow you to pan audio left or right
within the pair.
Note that each device name begins with "WavOut." This is to remind you that these are
software devices, and not always connected directly to output hardware. Instead they are
connected to the Delta 1010LT’s internal patchbay/router and may be sent to one of many
destinations. For more on the patchbay/router, see the Patchbay/Router section of the
Delta Control Panel software discussion.
17