McDATA 4314 Fibre Channel Switch Module Installation Guide
3-8
Installing a Switch
Configure the Switch Module
You can configure the switch using the EFCM BASIC application or the
command line interface. To configure the switch using EFCM BASIC, click the
Open Configuration Wizard radio button in the Initial Start dialog, then click
the Proceed button. The Configuration wizard explains and prompts you for
the following configuration information:
• Archive template file
• Switch domain ID (1–-239)
• Domain ID Lock (Locked/Unlocked)
• Switch name
• Permanent IP address
• Permanent subnet mask
• Permanent gateway address
• Permanent network discovery method
• Date and time
• Admin account password
• Create a configuration archive?
NOTE: Refer to the Reset command in the McDATA 4314 Command Line Interface
Guide for information about configuration default values.