Filter
Top Products
5
vents (ventilation holes), etc. Do not look at the
illumination lamp directly by opening the cabi-
net while the illumination lamp is turned on.
The illumination lamp also emits ultraviolet rays
and the light is so powerful that your eyesight
can be impaired.
• Do not drop, hit, or damage the light-source
(lamp unit) in any way. It may cause the lamp
to break and lead to injuries. Do not use a
damaged lamp. If the lamp is broken, ask your
dealer to repair it. Fragments from a broken
lamp may cause injuries.
• The lamp used in this projector is a high pres-
sure mercury lamp. Be careful when disposing
of the lamp. In case of doubt on how to do this,
please consult your dealer.
• Do not ceiling-mount the projector to a place
which tends to vibrate; otherwise, the mounting
fixture of the projector could be broken by the
vibration, possibly causing it to fall or overturn,
which could lead to personal injury.
Use only the accessory cord designed for this
product to prevent shock. The power sup-
ply voltage rating of this product is AC120
V, AC100 V – AC240 V, and the power cord
attached conforms to the appropriate power
supply voltage. Use only the power cord des-
ignated by your dealer to ensure Safety and
EMC. When used on an alternative power
supply voltage, the power cable may need to
be changed. Ensure that the power cable used
for the projector is the correct type for the AC
outlet in your country. If necessary, consult
your product dealer.
For United Kingdom For European countries
Power cable
Power supply voltage: AC 120 V
DO NOT allow any unqualified person to install
the unit. Be sure to ask your dealer to install
the unit (e.g. attaching it to the ceiling) since
special technical knowledge and skills are re-
quired for installation. If an unqualified person
performs installation, it may result in personal
injury or electric shock.
WARNING:
Do not cut off the main plug from this equip-
ment. If the plug fitted is not suitable for the
power points in your home or the cable is too
short to reach a power point, then obtain an
appropriate safety approved extension lead or
adapter or consult your dealer. If nonetheless
the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a
possible shock hazard by inadvertent connec-
tion to the main supply. If a new mains plug
has to be fitted, then follow the instructions
given below:
WARNING: THIS APPARATUS MUST BE
EARTHED.
IMPORTANT: The wires in the mains lead on
this product are coloured in accordance with
the following code:
Green/yellow: Earth.
Blue : Neutral.
Brown : Live.
As these colours may not correspond with
coloured markings identifying the terminals in
your plug, proceed as follows:
• The wire which is coloured green-and-yellow
must be connected to the terminal which is
marked with the Earth/Ground symbol, the
letter E or the safety earth or coloured green or
green-and-yellow.
• The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
• The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
When replacing the fuse, be sure to use only
a correctly rated, approved type, and re-fit the
fuse cover.
IF IN DOUBT, CONSULT A COMPETENT
ELECTRICIAN.