Filter
Top Products
8 Installation Guide
Installation Guide
* DIP switches can also be managed via console commands or through Metrobility NetBeacon or
WebBeacon management software. Refer to the
Command Line Interface Reference Guide
,
NetBeacon Element Management Software Installation & User Guide
or
WebBeacon Management
Software Installation & User Guide
for software management information.
1
2
Follow the steps outlined in this section to install and start using the Radiance
multi-rate line card.
NOTE: Electrostatic discharge precautions should be taken when handling any
line card. Proper grounding is recommended (i.e., wear a wrist strap).
Unpack the Line Card
Your order has been provided with the safest possible packaging, but
shipping damage does occasionally occur. Inspect your order carefully
for damage that may have occurred during shipment. If you discover
any shipping damage, notify your carrier and follow their instructions
for damage and claims. Save the original shipping carton if return or
storage of the unit is necessary.
Set the DIP Switches
Two sets of 6-position DIP switches are provided on the R380 line
card. These switches, labeled SW1 and SW2, are used to enable/disable
functions or to set the initial data rate. The default settings for the two
banks of DIP switches are shown below.
Default DIP Switch Settings
123456
L
L
R
1
L
B
C
K
1
L
L
R
2
L
B
C
K
2
L
L
C
F
SW1
SW2
When setting DIP switches
*
, the UP position is when the lever of the
switch is pushed away from the circuit board. The DOWN position is
when the lever of the switch is pushed toward the circuit board.