Filter
Top Products
Radiance Multi-Rate Line Card 9
Configuring the Data Rate
SW2 is used to set the initial data rate on the R380. The data rate is
determined by the 6-bit binary code derived from the position of the
DIP switches. The table below describes the settings supported by the
multi-rate line card. 1=UP, 0=DOWN. The default setting, which
automatically detects the data rate, is highlighted in yellow.
NOTE: The initial DIP switch setting may be overridden through software.
noitisoPhctiwSPID
,etaR
spbM
locotorP
123456
000000 ssapybRDClocotorpynA
100000 0637.443-SD
010000 0048.151-CO
110000 0000.521IDDF/tenrehtEtsaF
001000 5213.331331-CF
011000 0025.5511-MTS/3-CO
000100 0000.002002-NOCSE
100 100 0526.662662-CF
001100 0052.135135-CF
011100 0080.2264-MTS/21-CO
111100 3415.666)CEF(4-MTS/21-CO
000010 0000.000,1devreseR
100010 0005.260,12601-CF
010010 0000.052,1tenrehtEtibagiG
10 10 10 0000.005,1devreseR
0 110 10 0000.000,2devreseR
111010 0000.521,25212-CF
000110 0000.052,2devreseR
100 110 0000.573,2devreseR
010110 0023.884,261-MTS/84-CO
110110 0000.005,2devreseR
001110 0000.526,2devreseR
10 1110 0750.666,2)CEF(61-MTS/84-CO
1 1 1 1 1 1 otuA
tceted-otua,locotorpnwonknU
)TLUAFED(