Filter
Top Products
3. Operations
Creating a descriptive infeed name
The Set Infeed Name command assigns a descriptive name to an infeed. This descriptive name is displayed
when the Show Traps command is issued.
To create a infeed name:
At the AmpMeter PDU: prompt, type set infeed name, followed by the absolute infeed name, then the
descriptive name of up to 24 alphanumeric and other typeable characters (ASCII 33 to 126 decimal - spaces
are not allowed). Press
Enter.
Example
The following command adds the descriptive name HQ_1_Infeed_A to the infeed on the AmpMeter PDU:
AmpMeter PDU: set infeed name .aa HQ_1_Infeed_A<Enter>
Displaying Infeed information
The Show Infeeds command displays information about all infeeds. This information includes the absolute and
descriptive infeed names.
To display tower information:
At the AmpMeter PDU: prompt, type show infeeds and press Enter.
Example
AmpMeter PDU: show infeeds<Enter>
Input Input
Feed ID Feed Name
.AA HQ_1_Infeed_A
.AB HQ_1_Infeed_B
.BA HQ_2_Infeed_A
.BB HQ_2_Infeed_B
Displaying the firmware version
The Version command displays the firmware version.
To display the firmware version:
At the AmpMeter PDU: prompt, type version and press Enter.
Performing a warm boot
The Restart command performs a warm boot of the AmpMeter PDU.
NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this
command.
To perform a warm boot:
At the AmpMeter PDU: prompt, type restart and press Enter.
TCP/IP Administration
NOTE: A restart of the AmpMeter PDU is required after setting or changing ANY TCP/IP configurations. See
Performing a warm boot on page 28 for more information.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the AmpMeter PDU: prompt, type set ipaddress, followed by the IP address and press Enter.
Example
The following command sets the IP address to 12.34.56.78:
AmpMeter PDU: set ipaddress 12.34.56.78<Enter>
Page 28 - 301-0399-3 Rev B.