March 10, 2009 Dolphin Interconnect Solutions 45
www.dolphinics.com
Sample Output
The fio-status command alone displays abbreviated information on all installed
ioDrives:
fio-status
Found 2 ioDrives in this system.
Fusion-io driver version: 1.2.4.3
fct0 Attached
ioDimm3 SN:0719 Firmware v11791
92 GBytes unformatted capacity.
fct1 Not attached
ioDimm3 SN:0299 Firmware v11791
154 GBytes unformatted capacity.
The fio-status command with the –a parameter and no device name displays all the
information available on every installed ioDrive.
fio-status -a
Found 2 ioDrives in this system.
Fusion-io driver version: 1.2.4.3
fct0 Attached
-c
Count: Report only the number of ioDrives installed.
-a
All: Print all available information for each device. The fio-status
command displays the following information:
• Serial number
• Part number
• Manufacturer's name
• Manufacturing date
• Firmware version at manufacturing time
• Size of the device, out of total capacity
• NAND manufacturer
• NAND cell type (SLC, MLC, or
unknown)
• Size of the device in blocks
• Size of a block in pages
• Size of a page in bytes (including ECC
overhead)
• Number of pads, planes and banks
• Size of an ECC-protected unit (includ-
ing check-bit overhead)
• FPGA ID
• Hardware UID
• Bus ID
• Vendor ID
• Subsystem vendor and device IDs
• Device ID
• PCI slot number
• Internal temperature (avg. and max.,
since driver load) in degrees Centigrade
• Ambient temperature, in degrees Centi-
grade
• Internal voltage: avg. and max.
• Auxiliary voltage: avg. and max.
• Health status: Healthy, Marginal, or
Degraded, based on the percentage of
good erase blocks on the device
• Percentage of good data
• Percentage of good blocks
• Percentage of good metadata