Filter
Top Products
Command Line Interface
4-126
4
Default Setting
All IP pool addresses may be assigned.
Command Mode
Global Configuration
Example
ip dhcp pool
This command configures a DHCP address pool and enter DHCP Pool
Configuration mode. Use the no form to remove the address pool.
Syntax
[no] ip dhcp pool name
name - A string or integer. (Range: 1-8 characters)
Default Setting
DHCP address pools are not configured.
Command Mode
Global Configuration
Usage Guidelines
•
After executing this command, the switch changes to DHCP Pool
Configuration
mode, identified by the (config-dhcp)# prompt.
• From this mode, first configure address pools for the network interfaces (using
the network command). You can also manually bind an address to a specific
client (with the host command) if required. You can configure up to 8 network
address pools, and up to 32 manually bound host address pools (i.e., listing
one host address per pool). However, note that any address specified in a
host command must fall within the range of a configured network address
pool.
Example
Related Commands
network (4-127)
host (4-132)
Console(config)#ip dhcp excluded-address 10.1.0.19
Console(config)#
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#